the step #2 box only goes to 1990 model as oldest! it is a 1964 Chrysler new yorker

Engine light came on then care started being sluggish, jerking like.

Just trying to pinpoint the problem

When I disengage the emergency brake and it doesn't release and the car doesn't move what may be the problem

steering stopped working why

Just started tapping today. Should I add Lucas? What should I do? Need to drive 110 miles.

I need to add power steering fluid to a new Yorker 1989 where does it go?

The car overheated, then the battery died. Now it won't start. I put cheap antifreeze in and afterword noticed on the label it read 'do not add water' which I did. One 1/2 gallon antifreeze to one 1/2 gallon water. I then added 1/4 gallon of antifreeze labeled 'must add water' and that was all I could put in since the battery was dead.
The temperature will be around 4 degrees tonight. Is the car in danger of cracking it's block in the sub zero temperatures and if not, how warm should I wait for it to get till I try to start the engine again?

Car trys to crank but only gives 1 slow turn. Battery, alternator and starter are new. It is a 1964 new yorker.

Replaced transmission control module but still wont shift in to higher gears and now gets stuck in first when i brake and it over heats.

at first my headlights were going off and on and then my dashboard went completely out. i baught a dimmer switch and the problem stopped for a while then all of the sudden my tailights went out. now my brake and signal light work in the back but the taillights dont work. how can i fix that?

i drove my car around all day. when i parked it, it wouldnt crank. i thought it was that faulty security system i had but the security light wasnt on. so my friend thought it was the fuel pump and so i replaced it and the strainer and it still wont crank. can you help me.

Was driving and car just quit all of a sudden and now has no spark. what is the most likely reason for this

If you can tell me I can replace them

miles. Car ran fine. When I came to stop at stop sign car died. Will not start. Replaced coil pack, plugs, crank shaft positioning senbbc.cosor, checked fuel injectors, fuel filter, fuel pump,.gives codes 12, 41, & 55. Help please.

Lid still opens by key or remote.....or was

My car started just fine then I needed to wiggle the shifter in and out of park to get it to start. when that doesn't work if you move the wheel up and down and wiggle the shifter around it would start now that's not working. I took apart the steering wheel housing to see if it was a loose wire and there are no wires in there. if anyone can give me some suggestions I am willing to try anything at this point to get it to start. Thank you.

Solenoid pack changed..checked wiring.. Had radio replaced before...I noticed one wire in conduit cut..re spliced.I don't see ground wire going from granny to body..where do I buy ground wire..this car stressing me out...help.203 821.1190..text me if u have.an answer.

changed oil and filter

Ive looked on youtube and all signs point to something else other than the struts... it doesnt bounce excessively when goi g over a bump... it actually seems pretty stiff... pls help anybody. I need this fixed and quick

I was driving about 50mph and then rpm started jumping from 1 to 1 1/2 extremely fast and then died. It won't start up. It also turns over really fast like there isn't alot of commpretion. What do you think it is?

I was driving about 50 mph and rpm gauge suddenly started bouncing between 1 and 1 1/2 and then died. I couldn't get it to start back up and when I tryed to it sounded like it had a lot less compression. No codes were thrown. What do I do?