Chrysler 300 QuestionsRefine by vehicle
My egr sensor came on three weeks ago
I was told it was the fcm could it be any thing else if that's not the problem
The car will click at a stop light and it will run really rough but I turn it off and on and it will run fine ???
My car overheated I replaced everything but it still over heats. Why got no oil in water or water in oil..when you take off car is real sluggish..why?HELP...
I was coming home from a friends an hr away and my heater cut out just started blowing cold air and then about 10 mins later my overheat light came on but my gauge wasnt showing it. It was still in the middle between hot and cold then about 5 mins maybe a lil less later smoke came from the exhaust and my temp gauge shot up to hot then shot straight down to cold stayed at cold and my throttle light came on and the overhead light came off. I was able to get to my sister's turned it off and steam was coming from under the hood. Popped it and antifreeze blew up everywhere. Put water in the antifreeze reservoir and steam started pouring out on top at the coolant outlet housing it's like it melted by the screws. What would cause it to get that hot and do that out of no where? Once I replace the coolant outlet housing will thay fix it or is something else wrong that lead that part to break like that? The car was running perfectly fine until this happened. There was no leaks either.
The gear shifter is failing causing the car to roll out of the drive or down the street, according to the report on the news. Is there a recall on this.
The problem is with 2012 to 2014 model 300 Chrysler.
Top radiator hose is hot,the bottom hose is warm and hoses going to the heater core are cold
Come with car fax but doesn't say if the problem was fixed..is it expensive to replace should I get the car..that is the only problem
Everything on the screen and radio is not working. Someone said body control module maybe? They said it's not a fuse!
This just happened. Some a/c is coming out of a vent that faces the door but not much.
Work fine yesterday.
Even when I release parking brake it stays on. This happens most of the time but not always
In between changing the spark plugs and today I drove long distance over the holiday. On the way to work ETC light came on, got to work, turned car off and back on, no warning light, drove it for lunch less than 1/2mile, no light, drove it home within 5minutes of driving the warning light is back on stayed on all the way home, hour drive, no highway. Sounds rough, still drives ok. Please help!! Any suggestions!!
my etc light started flashing and i lost all power. I changed the gas pedal, throttle body and then then ecm. The light is still flashing. I have checked all the connections I can find. I haven't tried driving on the road yet. While in park I can accelerate until I engage the brake pedal and it loses all acceleration. Any help would be appreciated. thanks
my air bag light stays on had computer test it front drivers side sensor is not registering message is it a big job to replace sensor its a Chrysler 300 2014 I researched a u tube video and went through of the steps to clear light and still light appears can you give me a few other reasons why the light stays on thanks
I can't get some stuff inside my car to work even though I set the settings. Like the lighter/power source and the automatic seat entry mechanism.
rear brake light
Water has gotten into the car key, before we noticed, we tried turning the car on. It turned on for a second and then cut off. Now it won't start at all. How can we fix this?
Codes r-P0606-internal control processor, P0300- multiple misfire, P0335- crankshaft position sensor, car will run for a minute then stall, replace battery, replace crankshaft position sensor, replaced cam position sensor, replace integrated control module, I just bought the car an it drove fine when I looked at it an then drove down the street an now only runs for a min before stalling, it sat for a few months, no rat damage or any other sign of wire damage, feels like chasing a ghost, grounds r all clean an tight
The manager threatened me when I said I was going to take my car elsewhere to get the repairs done due to miscommunication and unprofessional employees
My car ran hot one time oil in it know my engine knocking loose pressure run hot when I try to drive it
#1 cylinder rotted , burned 2 quarts of oil in 2 months , posted earlier today.
oil from last oil change 2 months ago , car just over 45000 , said power train warreny will cover replacing engine , could trans possibly be affected also , oil was sent through and out exhaust system ?
How do I diagnose it? PLEASE CALL ASAP 404 574 8253 THANK YOU
NO START CONDITION DEALER DIAGNOSED TRANSMICCION CONTROL MODULE
I have a new 2016 300 and I have heated driver/passenger seats. I want to have AT LEAST the drivers seat replace with one that has the ventilated/cool seat. About how much labor would that entail and about how much would I be looking at to do so?
Only my lights turn on when I turn my key. Power is strong with engine and red lighting bolt comes on. Just the engine will not turn on. Also if If I hot wire the starter the car will not turn over. It seems like the gas is not getting to the engine. I hear the gas pump turn on. Whas up?
I burly have 1yr with car and not satisfied cause its new I had taken in for parts n parts
Was driving my car a short distance and noticed a humming noise coming under the hood...Had my air on so turned that off thinking maybe something was wrong there.....car is performing fine, not overheating, just this noticeable humming noise....sat with car in park and revved the engine, and the noise revved up also...have any ideas what might be wrong? thank u
The seat and steering wheel is supposed to go back then forward when door is opened and closed. The motor still works and the preset info works, just not when the door is opened anymore.
When it tries to change into second gear it sputters like it wants to change but it wont.