Close

Chevrolet Corsica Questions

Get answers to questions about your Chevrolet Corsica at RepairPal. Find solutions, diagnose problems and get back on the road.

Refine by vehicle
×
Choose your vehicle
No car image 94a1663db56199c5353592009e34aaa51078a2469bed068bb8d6f0ba43accf97
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more
163
questions

Can someone tell me what the average vacuum reading should be on a 1996 Chevy Corsica 3.1? Mine is only showing 15hg. Thanks

i tried putting it into neutral to get it started after a jump from a ComEd truck didnt help, & pressing the brake pedal was making the radio act up

I notice today that i can hear the pump but once i get home my car shuts off. So i turn it over but wont start. I dont hear the pump. But if i tap the tank it starts running my fuel pump. It sounds like a bunch of hornets in my tank.

The knock sensor broke off when it was being removed from the block, the threads are still there and have been filed down. Working space is very limited..difficult to reach. How can the remaining threads be removed?

My 96 corsica when it sits for awhile when I put it gear have to rev up motor to get it to move once it moves for awhile the transmission feels like it engages fully just had it flushed and filter changed

What is causing my car to make a sound when turning, sounds like rubber squeaking, coming from the steering wheel. Thanks Joey WA

the steering wheel. Sounds like rubber squeaking. Thanks Joey

my oil is not low either it also stayed on after an oil change

breaks. happens all the time.

Where is it?

Where is this at?

I have a 1988 Corsica. There is radiator fluid leaking from the HVAC elbox drainage. Every time I refill the radiator with fluid it drains out the elbow drainage. Other times it just goes somewhere. I have no idea.

What size wrench does one need to remove the Heater outlet pipe connector. I have made a guess of 32mm. A Crescent wrench will not get the job done. Thanks

new battery...starter....

Both were working until I removed the upper and lower intake manifold to repair a coolant and vacuum leak. I suspect I broke a wire somewhere, I tested the 3 wires coming from the coolant sensor to the harness connection near the Alternator, tested ok. I don't know where the wires go from the low coolant sensor and the coolant temp sensor to the dash. Thanks

saw no spark w plugs rwemoved

Engine loses power, stalls when cold, after warming up a bit, it runs fine. Have replaced both oxygen sensors. don't know about the coolant temp sensor. Thanks

I went into a store and I came out to start my car it wouldn't turn over it made the sound of wanting to start but won't turn over, so the next day I came back to see if it will start and it did. .. any reason why it did this I will be so thankful

This is the third alternator in 2 months, a new one was installed yesterday and today the light is back on, its not the fuse that was also replaced.