» » »

Car Recalls

Recalls are issued for cars with safety-related defects or problems

2002 Nissan Sentra recalls

 

Engine, December 31, 2007

RepairPal Expert Overview:

On certain passenger vehicles equipped with a 2.5L engineThe crankshaft position sensor can overheat causing a brief interrupion in the signal output. If the interupption of the signal is so brief that the ECM Electronic Control Module dose not have time to diagnose the condition, the vehicle may shut off creating the risk of an accident. The dealer will reprogram the ECM free of charge. The Nissan recall # is R0606

Learn more »

Engine, December 22, 2003

RepairPal Expert Overview:

The circuit board for the crank position sensor and cam position sensor may have improper solder joints. This could cause the Service Engine Soon lamp to come on, the engine may not start, you could experience reduced power, or the engine may stall without warning, which could result in a crash. Dealers will replace the the crank position sensor, cam position sensors, and in some cases, the variable timing control sensors. The recall began on December 22, 2003. The Nissan recall number is R2022 and the Infiniti recall number is R3021.

Learn more »

Electrical & Lights, December 22, 2003

Summary: ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH THE QG18DE ENGINE OR QR25DE ENGINES, THE FOAM MATERIAL USED FOR THE INTERIOR LINING OF THE ELECTRONIC CONTROL MODULE (ECM) BOX EMITS SULFUR AS IT CURES.

Learn more »

Engine, December 15, 2003

Summary: ON CERTAIN ELECTRIC VEHICLES, THE FRONT SUSPENSION TRANSVERSE LINK¿S BALL JOINT BRACKET MAY BREAK FROM STRESS CONCENTRATION AT A NOTCH CREATED BY SURFACE ROUGHNESS AND THE SHAPE OF THE MATERIAL CUT-LINE.

Learn more »

Engine, July 28, 2003

Summary: ON CERTAIN VEHICLES EQUIPPED WITH THE 2.5 LITER ENGINE, THE EXHAUST PIPE HANGER PIN MAY CATCH DEBRIS FROM THE ROAD THAT COULD BE IGNITED BY CONTACT WITH THE MAIN CATALYST.

Learn more »

Body, Interior & Misc., March 18, 2002

Summary: ON SOME PASSENGER VEHICLES EQUIPPED WITH A NISSAN-APPROVED ACCESSORY FLOOR MAT THAT WAS INSTALLED EITHER AT THE ASSEMBLY PLANT OR BY THE DEALER, DUE TO THE LENGTH OF THE DRIVER SIDE FLOOR MAT, A SMALL AMOUNT OF MAT MOVEMENT COULD CAUSE THE MAT TO INTERFERE WITH THE ACCELERATOR PEDAL AND NOT ALLOW THE PEDAL TO RELEASE AFTER IT IS DEPRESSED.

Learn more »

Electrical & Lights, January 14, 2002

Summary: VEHICLE DESCRIPTION: CERTAIN PASSENGER VEHICLES FAIL TO COMPLY WITH REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE VEHICLES WERE MISSING TAMPERPROOF CAPS THAT PREVENT HORIZONTAL HEADLAMP ADJUSTMENT.

Learn more »