2001 Nissan Pathfinder Recalls
Airbags use a chemical reaction contained in an inflator module to create the pressure necessary to inflate the bags when deployment is required. These vehicles are being recalled because the front passenger airbag inflator may produce excessive internal pressure when deployed. As a result, the inflator module could rupture, causing metal fragments to strike vehicle occupants. Dealers will inspect and replace any defective passenger front airbag inflator modules found.
In areas where winter road salt is used, a mixture of snow/water and salt may enter an assembly location hole in the upper strut housing. This corrosive mixture can collect on the mating surface of the strut housing panel and the inner hood ledge assembly; over time, this can cause rusting of the strut tower housing. The rust can weaken the housing, causing it to crack and pull away from the inner hood ledge assembly. This can lead to grinding noises and increased steering effort, which, if severe enough, can cause the steering column to break. This would result in a loss of steering control, increasing the risk of a crash. Dealers will inspect the strut housing and repair the vehicles as necessary. An interim notification letter should be mailed to owners prior to May 16, 2011.
ON CERTAIN VEHICLES ORIGINALLY SOLD IN OR CURRENTLY REGISTERED IN THE STATES OF CONNECTICUT, DELAWARE, IOWA, ILLINOIS, INDIANA, KENTUCKY, MASSACHUSETTS, MAINE, MARYLAND, MICHIGAN, MINNESOTA, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, TENNESSEE, VERMONT, VIRGINIA, WEST VIRGINIA , WISCONSIN AND THE DISTRICT OF COLUMBIA, DURING THE COATING PROCESS OF THE FUEL FILLER TUBE ASSEMBLY, AN INSUFFICIENT AMOUNT OF COATING MAY HAVE BEEN APPLIED AT THE LOWER MOUNTING BRACKET. THIS COULD RESULT IN AN OPENING IN THE COATING WHICH CAN ALLOW WATER TO ENTER AND MAKE CONTACT WITH THE BARE METAL OF THE TUBE.
VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES. SOME OF THE BRACKETS USED TO ATTACH THE TWO GAS STRUTS TO THE REAR DOOR (HATCH) MAY HAVE BEEN IMPROPERLY MADE. AT HIGH AMBIENT TEMPERATURES, THE INCREASE IN GAS PRESSURE IN THE STRUT(S) COULD CAUSE ONE OR BOTH BRACKETS TO BEND, RESULTING IN THE STRUTS DETACHING FROM THE BRACKET(S) WHEN OPENING OR CLOSING THE REAR DOOR.