2004 Mercedes-Benz E500 Recalls
There is a faulty software calibration that affects several areas including shutting off the fuel supply in a collision. This could cause a fire hazard during an accident. Dealers will reprogram this software. The Mercedes-Benz recall number is 2008 070001. This recall began during August, 2008.
Due to deterioration of the wiring harness connection or failure of the hydraulic pump, the sensotronic brake control (SBC) system may default to the hydraulic back-up mode. In the back-up mode, the driver has braking power sufficient to stop the vehicle, but greater brake pedal pressure is required and brake pedal travel will be noticeably longer. Dealers will install a bracket and replacement ground wire to the SBC pump unit on all affected vehicles. Additionally, dealers will inspect and replace the SSC pump unit in certain SL models. The Mercedes-Benz recall numbers are 2005070007 AND 2005110001.
High mileage combined with a high number of brake actuations, or a high brake actuation frequency, can cause the pump motor of the SBC to run out of permissible tolerances. As a result, excessively high pressure may build the high pressure line of the brake system. If this occurs, the system will switch into the hydraulic function mode as designed. Sensotronic brake control is disabled when the brake system is functioning in the hydraulic mode. Dealers will inspect the SBC hydraulic unit and replace it if necessary to correct this concern. The Mercedes-Benz recall number is 2004 050014.
Some seat belt buckles may have a burr on a metal component of the locking mechanism. This could prevent the seat belt from locking under certain conditions. In the event of a crash, the seat occupant may not be properly restrained, increasing the risk of injury. Dealers will replace the affected seat belts. This recall is expected to begin on December 22, 2003. The Mercedes-Benz recall number is 2003 120006.