The fuel tank shut off valve may allow fuel to enter into the fuel tank emission system unintentionally. This may result in a fuel leak to the ground and engine stalling. Dealers will inspect the vehicle's fuel shut off valve and replace it as necessary, as well as replace any further affected fuel tank emissions system components free of charge to correct the concern.
Mazda Mazda3 Recalls
The powertrain control module (PCM) may incorrectly assume that the charging system has failed, in the event that water causes slippage of the alternator belt. This can cause needed vehicle accessories and functions such as power steering or windshield wiper operation to fail. Dealers will reprogram the PCM with updated software free of charge to resolve the concern.
The ground terminal of the windshield wiper motor may have been bent during vehicle assembly. Due to the bent terminal, over time, the electrical resistance of the motor circuit may increase to the point that the windshield wipers may stop working. Loss of wiper function in adverse weather could increase the risk of a crash. Dealers will install an additional ground harness on the wiper motor to correct this concern. This recall is expected to begin by July 15, 2011. The Mazda recall number is 6411F.
Mazda is recalling 2007–2009 Mazda 3 and Mazda 5 vehicles due to a sudden loss of power steering assist that can occur at any time. A sudden loss of power steering assist adversely affects the driver's ability to steer the vehicle, increasing the risk of a crash. Starting in September 2010, Mazda will mail notification letters to owners with information about the recall.
Due to a fault with the electronic information related to the yaw rate sensor, the electronic stability control may not function as expected. Dealers will replace the affected unit to correct this problem. This recall is expected to begin by July 14, 2009. The Mazda recall number is 5509E.
The engine wiring harness may be routed too close to the starter, resulting in damage to the harness caused by normal engine vibration. If the harness is damaged, engine control and/or transmission shift malfunctions may occur. In some cases, the main fuse could blow, causing the engine to stall and not restart, increasing the risk of a crash. Dealers will inspect and repair the harness. In addition, a protector clip will be installed to prevent future damage. This recall is expected to begin by May 6, 2009. The Mazda recall number is 5409D.
On two passenger vehicles, a crack in the solder connection attaching the acceleration sensor in the SAS unit made contact with the base plate ,damaging the solder connection. The dealer has repaired the two cars involved. The Mazda recall # is 2504K
A crack in the airbag crash zone sensor housing can allow water to enter the sensor, causing illumination of the airbag warning light. As a result, the airbag will not deploy as designed in certain types of frontal crashes, increasing the risk of injury to the driver and front seat passenger. This recall began during October 2004. The Mazda recall number is 2304J.