» » »

Car Recalls

Recalls are issued for cars with safety-related defects or problems

2002 Mazda Tribute recalls

 

Engine, July 26, 2012

RepairPal Expert Overview:

Mazda Tribute models equipped with a V6 engine are being recalled because inadequate clearance between the engine cover and the speed control cable connector could result in a stuck throttle when the accelerator pedal is fully or almost fully depressed. This risk exists regardless of whether or not the speed control (cruise control) is used.

A stuck throttle may result in very high vehicle speeds and make it difficult to stop or slow the vehicle, which could result in a crash. Dealers will correct this concern by increasing the engine cover clearance. Remedy parts are expected to be available in mid-August. Until then, dealers will disconnect the speed control cable as an interim remedy if parts are not available at the time of an owner's service appointment. The Mazda recall number is 6812G.

 

Learn more »

Brakes, January 19, 2012

RepairPal Expert Overview:

The brake master cylinder reservoir cap can leak brake fluid. Leaking brake fluid can come in contact with the antilock brake system (ABS) module wiring harness. As a result, corrosion can develop in the module electrical connector, which can cause the connector to melt, smoke, or possibly catch fire. Dealers will replace the brake master cylinder reservoir cap and modify the ABS electrical system to correct this concern. The Mazda recall number is 6712A.

Learn more »

Brakes, May 9, 2007

Summary: ON CERTAIN SPORT UTILITY VEHICLES EQUIPPED WITH ANTILOCK BRAKES (ABS), THE ABS MODULE CONNECTOR MAY HAVE MISSING OR DISLODGED WIRE SEALS. THIS CONDITION COULD ALLOW CONTAMINATION TO ENTER THE MODULE CONNECTOR, CREATING A POTENTIAL FOR AN ELECTRICAL SHORT.

Learn more »

Body, Interior & Misc., March 31, 2005

Summary: CERTAIN 2004-2005 SPORT UTILITY VEHICLES AND CERTAIN 2001-2003 SPORT UTILITY VEHICLE HAVING REAR LIFTGATE COMPONENTS SERVICED WITH 2004 EQUIVALENT COMPONENTS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 206, 'DOOR LOCKS AND DOOR RETENTION COMPONENTS.' THE REAR LIFTGATE LATCHING SYSTEM DOES NOT MEET THE INERTIA LOAD REQUIREMENT IN ONE DIRECTION.

Learn more »

Drive Train, January 28, 2005

Summary: ON CERTAIN SPORT UTILITY VEHICLES, THE ACCELERATOR CABLE MAY PREVENT THE THROTTLE FROM RETURNING TO THE IDLE POSITION.

Learn more »

Drive Train, May 3, 2004

Summary: ON CERTAIN SPORT UTILITY VEHICLES EQUIPPED WITH 3.0L V6 DURATEC ENGINES , DURING DECELERATION, THE ENGINE CAN STALL.

Learn more »
Ask a Question