X

2007 Jeep Commander Recalls

Electrical & Lights,July 21, 2014
RepairPal Expert Overview:

While operating the vehicle the driver may hit the ignition key with their knee, accidentally moving the key out of the run position. If this were to occur the engine would turn off, affecting various safety systems and increasing the risk of a crash and/or personal injury. As of this writing, the remedy for this recall is still under development.

Drive Train,May 7, 2013
RepairPal Expert Overview:

The 4-wheel drive transfer case can direct engine power to the rear wheels only, all four wheels, or in its neutral position, non at all. These vehicles are being recalled because the transfer case can shift into its neutral position without warning. If this were to occur, engine power would not reach any of the drive wheels and the vehicle could not move under its own power. Dealers will reprogram the final drive controller which governs the transfer case to correct this concern.

Brakes,October 22, 2007
RepairPal Expert Overview:

Chrysler has recalled 2006-2007 Jeep Commanders and 2006 Jeep Grand Cherokees because the software programmed into the ABS electronic control module may allow a momentary delay in braking when coasting up a hill during certain conditions. This may cause a crash. Dealers will reprogram the ABS electronic control module with new software.

Brakes,October 22, 2007
RepairPal Expert Overview:

Some brake calipers may be made of an improper iron material. These brake calipers may fracture and cause brake loss. Dealers will inspect and replace affected calipers. The Jeep recall number is G35. This recall began on October 22, 2007.

Brakes,February 19, 2007
RepairPal Expert Overview:

A problem with the software for the ABS control module may cause the rear brakes to lock up under certain braking conditions. Dealers will reprogram the ABS electronic control unit. The recall began February 19, 2007. The Chrysler recall number is F50.