2004 Ford Escape Recalls
The front suspension lower control arm may corrode at its forward attachment, and may separate from the vehicle. Dealers will install a newly designed reinforcement cross-brace free of charge to resolve the concern.
Ford Escape models equipped with a V6 are being recalled because inadequate clearance between the engine cover and the speed control cable connector could result in a stuck throttle when the accelerator pedal is fully or almost fully depressed. This risk exists regardless of whether or not the speed control (cruise control) is used.
A stuck throttle may result in very high vehicle speeds and make it difficult to stop or slow the vehicle, which could result in a crash. Dealers will correct this concern by increasing the engine cover clearance. Remedy parts are expected to be available in mid-August. Until then, dealers will disconnect the speed control cable as an interim remedy if parts are not available at the time of an owner's service appointment. The Ford recall number is 12S37.
ON CERTAIN SPORT UTILITY VEHICLES EQUIPPED WITH ANTILOCK BRAKES (ABS), THE ABS MODULE CONNECTOR MAY HAVE MISSING OR DISLODGED WIRE SEALS. THIS CONDITION COULD ALLOW CONTAMINATION TO ENTER THE MODULE CONNECTOR, CREATING A POTENTIAL FOR AN ELECTRICAL SHORT.
CERTAIN 2004-2005 SPORT UTILITY VEHICLES AND CERTAIN 2001-2003 SPORT UTIITY VEHICLE HAVING REAR LIFTGATE COMPONENTS SERVICED WITH 2004 EQUIVALENT COMPONENTS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 206, 'DOOR LOCKS AND DOOR RETENTION COMPONENTS.' THE REAR LIFTGATE LATCHING SYSTEM DOES NOT MEET THE INERTIA LOAD REQUIREMENT IN ONE DIRECTION.
ON CERTAIN SPORT UTILITY VEHICLES BUILT WITH 3.0L V6 ENGINES, THE ACCELERATOR CABLE MAY PREVENT THE THROTTLE FROM RETURNING TO THE IDLE POSITION.