2010 Dodge Ram 2500 Recalls
Vehicles equipped with a diesel engine have an electric fuel heater. The electrical connectors may overheat. If the connectors overheat, the fuel heater may leak fuel, increasing the risk of a fire. Dealers will replace the harness side connector with a silver plated beryllium copper terminal service kit, and inspect the fuel heater for leaks, replacing it as necessary.
The left and right tie rod assemblies are part of the front steering linkage, Certain trucks are being recalled because the left tie rod can break unexpectedly. This can result in loss of steering control. Dealers will inspect the steering linkage and install a new left tie rod assembly as necessary to correct this concern. This recall supersedes a previous recall, some vehicles repaired under the first recall may require an additional repair.
Certain vehicles may have been assembled with a left outer tie rod ball stud that may fracture; others may have received the affected tie rod assembly as a replacement part during normal service. This condition tends to occur during low speed parking lot type maneuvers when the driver is making a tight turn. This condition could result in a loss of directional stability in the left front wheel, increasing the risk of a crash. Dealers will inspect the tie rod ends, replace the left outer tie rod end as required, and perform a front end toe alignment as needed. The manufacturer has not yet provided an owner notification schedule. The Chrysler recall number is L16.
Chrysler is recalling certain 2010-2011 Dodge Ram trucks equipped with a diesel engine and hydroboost brake system because the brake pedal may be slow to return after brake application. A slow returning brake pedal will cause the brake lights to be slow to extinguish, which can increase the risk of a crash. Dealers will replace the power steering reservoir cap in order to lessen the vent pressure in the reservoir.
Chrysler is recalling 2010 Chrysler 300, Dodge Challenger, Charger, Jeep Commander, Grand Cherokee, and Dodge Ram vehicles due to a problem with the wireless ignition node (Win) module, which can exhibit a binding condition of the solenoid latch. It's possible that the key can be removed from the ignition switch prior to placing the shifter in "Park," which can cause unintended vehicle movement. Dealers will inspect and replace the Win module free of charge.
Some vehicles may have been assembled with a deformed brake booster input rod retainer or no retainer at all. As a result, the brakes may fail without warning, increasing the risk of a crash. Dealers will install a new brake booster input rod retainer to correct this problem. This recall is expected to begin during February 2010. The Chrysler recall number is J37.