my mr2 is having a stalling problem starts and run but stalls when put into gear
What is your question?
not sure what it could be I have replaced the throttle position sensor, EGR vacuum solenoid, plugs and wires, transmission shift solenoids, distributor cap and rotor button, coil pack ,flushed and clean engine and tranny inside and out , and still having the same problem . the car starts and runs great but when put in gear stalls out will drive in L, and once little past 20 miles per hour able to put it in D and it will drive but has hardly any power.
Anyone know what it could possibly be?
RepairPal Certified shops can diagnose and repair your 1991 Toyota MR2. They provide transparent pricing with a minimum 12-month or 12,000-mile warranty on repairs and services.
Is the check engine light on? Going by your description , you can have it running and it will accelerate IF shifted into 'low' manually , but if put in 'drive' it struggles. Is it as if you have a manual trans , and are trying to start out in 2nd or 3rd gear? How many miles on trans. and what 'flush' procedure?
yes the check engine light comes on, mostly when the car is trying to stall. the car has 209k original tranny. and was a standard flush, drain, drop pan, replace filter, and the 2 shift solenoids, high-power air flush, then re-filled one quart Lucas tranny conditioner, the rest special fluid for imports, by castrol.
tranny shifts fine once it past 20mph and put into D from L, it drives fine but no quick acceleration hardly any power. but down shifts smooth as could be no pulling or slipping. but once it gets under 20 in D and press gas it stalls.
Yes normal power, and I will get to over 20 mph and then put up n D and will drive without stalling but as barely ne power and am able to get up past 70 mph, and as I slow down it down shifts smoothly.
I don't have a scanner, not able to take to a shop. Ty for your reply
GET A FREE DIAG AND EST FROM AAMCO THEN POST RESULTS B4 AUTH ANY REPAIRS