Honda won't start.

Yes. Sorry. Compression is 140 to 160 on all cylinders.

*Insufficient* fuel delivery OR ignition spark! .. IF a fuel is added to intake, will engine start or attempt to start?

It will attempt to start on its own occasionally. Adding fuel does not help.

Make sure the spark plugs are not 'fuel fouled' (wet with gas) may want to just go ahead and replace em... 'IF' it has *proper* spark, fuel/air delivery and compression, it has got to start up and run! .. Hold gas pedal on floor and try it... (Clear flood) .. Keep in mind the 'big rubber air tube' has GOT to be in proper place and tightly secured with NO LEAKS!

I replaced the plugs and 1 ignition coil. I will keep trying. Thank you so much for your help.

I know the plugs were replaced but pull a couple out and check em for gas covered tips .. It AIN'T gonna start with gas drowned plugs - new or not!!

Plugs are all good, clean and dry. Won't start with clear flood. With all of this being done would the main relay have anything to do with it? Or the computer? Don't have any diagram for pin out test for relay or computer. Does not help to add gas or starter fluid.

Since 'YOU SAY' it has proper spark, and compression and you are adding an '**adequate amount**' (?) of fuel to the engine - it is supposed to start and run for a second or two REGARDLESS of 'anything' else !! .. You were mistaken about OR have missed *something* during your testing .. Below is a link for troubleshooting : http://troubleshootmyvehicle.com/honda/3.0L/how-to-test-a-no-start-condition-1 Good luck with it!

It was a bad NEW crank position sensor. Thank you for all you help!

That makes sense .. That's what makes this type work so much FUN! Glad it's fixed.. Good work!!! ..Thanks for the reply!