What is your question?
·
·
What is your question?
I was going to install a remote starter and I cut into the orange wire at the ignition switch and accidentally touched the frame and I got a spark then the check engine light came on. I used my OBD tool and got a code of P0340. So I cleared the code and cranked the car up again and the check engine light came back on so I cut the car off checked the code again and this time the code came up as P0343. I have checked all the relays and the test light comes on when I ground 85 and power to 86 and 30, so I ground the test light and touch 87 and the light comes on each relay. Is there another way to check relays to see if they are putting out the right ohms or does that matter ? I check the fuses with a test light and also an ohm meter and they test good. What do I do now or what should I look for now ?
1 Reply
Damn,you asked that same damn question on May 14, 2015!! been almost 2 years now! throw that remote start in the trash,you have already cut one ignition switch wire,the orange wire and shorted it to ground one time! same exact question,word for word! so you cut the orange wire again? your last words in your question are "what should I look for now"? ANSWER>>>look for a new web-site and have that damn corvette crushed at the scrap yard!
You are right it is still not fixed but I am still waiting for the answer. I did everything you guys told me so maybe you have come up with something new.Will it shut down on me if I drive it anyway? I did get rid of the remote starter but still have the same problem.