What is your question?
·
·
What is your question?
When looking at serp belt it jumps forward the back to original position. I roll the engine over with 1/2 breaker bar so the motor in not seized. Put trans in last month I think it's the starter. Any ideas would be appreciated.
1 Reply
1-possibility: Have seen belt driven componet lockup and cause this..can try removing belt to see if it cranks ok then... You probably could force it to turn with breaker bar even if this is the case!.. Just a thought...
Good thought.....
Thought about what you said so I first I tried rolling the engine over by had couldn't get it to roll.i just thought I couldn't over come the compression cut I left the plugs in.so put a new battery in from other car because it was so dead from cranking on it.cranked it and it fired right turns out compressor was seized and snapped the belt since I don't have the cash to buy a new one I bypassed it till spring when it starts to warm up.thanks for the idea u got me in the right direction.