What is your question?
·
·
What is your question?
These two error codes pop up after diagnosing. This is a manual 5 speed car. I see everything is clean and clear no leakage. One more thing, i can smell some smoke when idling for more than 1 min at drivers side.
1 Reply
WELL, YOU MIGHT NEED A GAS CAP, IF IT ISENT THAT THEN LOOK FOR A CRACKED OR ROTED HOSE FROM THE ENGING TO THE FRAME DOWN THE FRAME TO THE TANK, YOU MIGHT HAVE TO DROP THE TANK IF THE HOSE BROKE OR ROTED AWAY UP ON TOP, ITS A LEAK AND THE TANK IS NO LONGER HOLDING PRESSURE. THE OTHER CODE, SOUNDS LIKE A CATYLETIC CONVERTER CODE OR AN O2 SENSOR AS FOR SMELLING SMOKE, PROBABLY A VALVE CONER GASKET LEAKING ON THE EXHAUST MANIFOLD, TIGHTEN DOWN YOUR VALVE COVER, IF THIS DONT WORK, THEN YOUR RUBBER GASKETS ARE HARD AS A ROCK, CRACKED AND NEED REPLACING.
first check very good for vaccum leak.open hood and start car,listen for hissing noise,air escaping from vaccum hoses.run your hand around all vaccum hoses and listen for a change in motor,also check gas cap seal,if seal is cracked or cap is not tight it will throw a code.vaccum leaks will sometimes throw false codes,and if you had it read at az,adv,or other parts chain they will put the code in their computer and print out probable causes of that code and try and sell you $300.00 worth of parts you dont need.the smoke smell is probably the valve cover leaking.if i am thinking right,your spark plugs are down inside the valve cover.if this is correct check your spark plug wires that go into valve cover and see if they have oil on the wires,if so you need to replace the valve cover grommets as well.if you have a code reader you can clear the code,or unhook battery for a few minutes,after you correct problem.is engine running ruff,skipping,vibrating,or running smooth