What is your question?
·
·
What is your question?
I've checked all the fuses. Charged the battery completely. Replaced the Camshaft sensor, Crankshaft sensor, 6 Spark Plugs, and 6 ignition coils. It has about a 1/2 tank of gas. It did show a code for crankshaft sensor but I cleared it out after replacing the sensor. But still won't start. What else can I try? BTW its a 3.0L 6cyl Auto, if that helps.
I've looked throughout the passenger side kick panel, not sure if this model is equipped with an inertia switch.
Do you have the owners manual?
Yes. I've consulted the owner's manual and no reference to an "inertia switch". I also searched the manual front to back for anything that might be relevant. So far no luck.
Try "Fuel Pump Cut Off Switch" index in back of the book... I'm almost sure it's got one!!!
No reference to a "Fuel Pump Cut Off Switch" in the index or any section in the Owner's manual. I've pulled the glove box down, the carpeting on the driver and passenger side, the trim panels to the passenger side kick panel, also the removable panel in the rear nearby the fuel fill-up. I still can not locate, at this point not too sure if it is equipped with one. I don't think fuel is the issue, I am able to pump the pedal and can smell fuel after a while. I think it may have to do with spark. What other components can I check out or replace? I've seen reference to the distributor assembly in forums, but sure what part that is? I also tried using another set of keys to make sure that there was no problem with a transponder in the key issue. I cleaned the Idle Air Control (IAC) valve, still wants to crank but not actually start. Not sure what else I can look at, any additional help would be appreciated.