How to change inner cabin filter?

if it has one,see below>>> Open the glove box on the passenger side of the vehicle. Remove the glove box from the dash by removing the 2 lower screws with a Phillips head screwdriver. Pull the glove box stops out of the plastic brackets that are holding them in. Set the glove box cover to the side. Locate the 3 bolts on each side of the lower cross bar that the glove box was attached to. The 3 bolts are at the very end of the cross bar. There is 1 10mm bolt and 2 8mm bolts. Remove the 3 bolts from each side with a 3/8-inch drive ratchet and a 10mm socket and a 8mm socket. You will have to slide the ratchet and socket between the plastic part of the center console and the 3 bolts on the cross bar. On the other end, you will have to slide the ratchet and socket between the right plastic cover and the cross bar. Turn these bolts counterclockwise to loosen and remove. Set the cross bar to the side. Remove the plastic cover from the right hand side of the glove box. There are 2 Philllips head screws holding the right hand side plastic cover in place. Unscrew them. Remove the wiring harness from the yellow plastic clip. The wiring harness is running in front of the cabin air filter and will need to be moved out of the way to get the cabin air filter out. Push the wiring harness over the top of the cabin air filter housing. Pull the door off of the front of the cabin air filter housing and set it to the side. Stick a flathead screwdriver inside of the cabin air filter housing and pry the cabin air filter towards the open end of the housing. Grab the handle on the end of the cabin air filter frame and pull straight out on it. Remove the filter from the frame. Slide the new cabin air filter into the cabin air filter frame. Slide the new cabin air filter frame with filter back into place inside of the cabin air filter housing. Put the door back on the front of the cabin air filter housing and lock in place. Slide the wiring harness back over the cabin air filter housing and press the wiring harness back into the yellow plastic clip.