What is your question?
·
·
Have an auto question? Local mechanics have answers.
Auto experts have answers.We'll send your question to trusted nearby shops.
What is your question?
5.2l Crawled under the vehicle to look for loud squeal when accelerating. After a while of looking I had noticed that the crank pulley and harmonic balancer both move out towards the front of the vehicle and when that happens the squeal starts. I am looking for some advice on how to continue. I am pretty handy but by no means an auto mechanic. I am guessing there are bearings or a collar that may be missing/damaged? Thanks in advance
2 Replies
Make sure the bolt is tight first. If you aren't too familiar with all this I suggest taking it to a shop. You don't want to take chances with the crank pulley.If you don't work on your own car then use this link to find a good shop near you. https://repairpal.com/repair-shops Alex
The bolt is tight. It too seems to move with the pulley and balancer. I have replaced pulleys in different applications but never on a car is all.
I should add that I can pull on the pulley by hand and it has about a 1/4 inch of slide to the front. Its not easy but it moves
I think IF the crankshaft *thrust bearing* was worn that much - engine would be knocking. Be aware the harmonic balancer is two pieces - the outer ring is separated from the center hub by a neoprene sleeve - they do slip sometimes - careful use of a pry bar should reveal the problem. Good luck!
I didn’t see the other post here when I answered - IF you can see the balancer retaining bolt move with the pulley - it must be a worn crankshaft thrust bearing problem. In that case - engine removal will be required for correct repair. I suppose you could TRY pulling the oil pan and installing new crankshaft bearings from the bottom - however the crankshaft normally needs to be re-machined. This is likely a little too involved for the average DIYer.