What is your question?
·
·
What is your question?
I replaced the master and slave cylinder I bled it but when I started it I lost all pressure in my clutch and wldnt go in gear I had also pulled out a thin piece of metal bout 2" long when I took out the slave cylinder so since replacing tht didn't Wrk I'm guessing my throw out bearing r something in the transmission messed up so I'm tryin to figure wat clutch kit goes in the trans
1 Reply
It isn't likely to be a mechanical clutch component problem ! ... Highly suspect improper installation of the master//slave cylinder combo - OR - air is still trapped within the hydraulic system. The master cylinder MUST have an ample supply of fluid at all times while bleeding - it MUST not be allowed to get empty .. IT can take *SEVERAL* attempts to successfully purge all air from the system. Recommend getting hands-on help with this - from qualified personnel - before condemning the clutch assembly. Good luck with it!