headlights

Raise the hood. You have a Torx/Hex head adjusting screw at the rear of the headlamp assembly. Alignment procedure: Position vehicle on a level surface perpendicular to a flat wall (25 ft.) away from front of headlamp lens. If necessary, tape a line on the floor (25 ft.) away from and parallel to the wall. From the ground up .(5 ft.), tape a line on the wall at the center line of the vehicle . Sight along the center line of the vehicle from rear of vehicle forward to verify accuracy of the line placement. . Rock vehicle side-to-side three times to allow suspension to stabilize.. Jounce front suspension three times by pushing downward on front bumper and releasing. Measure the distance from the center of headlamp lens to the ground. Transfer measurement to the alignment screen (with tape). Use this line for up/down adjustment reference . Measure distance from the center line of the vehicle to the center of each headlamp being aligned. Transfer measurements to screen (with tape) to each side of vehicle center line. A properly aimed left and right low beam headlamp will project the center of the low beam hot spot on the alignment screen below the horizontal center line and 6 in. right of headlamp center line. The high beam headlamps cannot be aligned. The high beam pattern should be correct when the low beams are aligned properly.