The total repair cost will vary based on the condition of your vehicle and the number of repairs needed to fix your symptom. Proper diagnosis will save you money by finding the exact repairs needed to fix your car right the first time.
If the door window motor fails, the window may not open or close, or it may operate intermittently. Traditionally, problems with power windows were caused by faulty switches or electrical wiring - especially the wires running between the door and the vehicle body that are subjected to repeated flexing. In these cases, the window might operate intermittently when the door is opened and closed. While this may still be the case on newer cars, it is increasingly common to find window motor problems that originate with a control module. Still, the switches and wiring should be checked thoroughly before replacing a window motor.
If one of the windows in a vehicle will not open or close properly, a failing door window regulator might be the cause. A window that is moving intermittently, or one that gets stuck on the way up or down, could also indicate a broken regulator. Other symptoms might include a clicking, chattering, or grinding noise when the window moves. In some cases a severely damaged window regulator could cause the window to drop inside the door.
When a switch can not make contact and close the circuit, the window cannot be raised and lowered. If the switch on the driver's door will not raise or lower the window in question, but the switch on the corresponding door works just fine, this is a good indication that there is a switch failure. This works the other way around, as well. If the switch on the door does not cause the window to function, but the driver's switch does, that is an indication of a passenger door window switch failure.
Due to the nature of electrical systems on modern vehicles, the range of problems these can cause are nearly limitless. However, there is a way to categorize them in two ways. Permanent and intermittent problems. Permanent problems appear and remain. This may be the vehicle will not start, the radio does not work, or the door chime will not turn off among many, many others. These problems are more straight-forward to diagnose since they present themselves at all time. This means there will always be a fault to find. Intermittent electrical problems, however, can be difficult or impossible to locate, since they appear then disappear without warning. The best case scenario for an intermittent issue is when replicating the problem is easily accomplished and understood. This allows a technician to make an issue semi-permanent, allowing them to find the fault. Other issues that come and go without warning and cannot be replicated on demand must occur when the technician is servicing the vehicle, otherwise there is no problem to correct. It is most important to understand that electrical system faults always require inspection, and can include the vehicle working in any manner, or not working at all.
Like we noted in the last section, general diagnosis symptoms are the most vague of the bunch. There are several diagnostic spectrums, electrical diagnosis, drivability diagnostics, engine diagnostics, transmission diagnostics, and the list could continue for about 5 or 10 more spectrums of diagnostics. The most important take-away here, is that general diagnostics are diagnostics that have no other spectrum in which they fit, or the problem is unknown. This means that any vehicle left outside of a repair facility with the keys and an authorization to perform diagnosis will be diagnosed under the general diagnosis spectrum.
When troubleshooting window issues in a Chrysler LHS, begin with the basics by inspecting the fuse and relay associated with the power windows. A blown fuse or faulty relay can often be the simplest fix, so check these components first. If the windows remain unresponsive, the next step is to examine the window motor, as a malfunction here can prevent movement. Should the motor be functioning, turn your attention to the window regulator, which is crucial for proper window operation. If the window is misaligned or not moving smoothly, the regulator may need repair or replacement. Additionally, consider the lift plates, as they can sometimes require replacement to resolve rolling issues. If the window bounces back unexpectedly, especially after a battery change, reprogramming the window may be necessary to reset its pinch protection feature. Lastly, if multiple windows fail simultaneously, it’s essential to conduct a thorough inspection, as this could indicate a more complex electrical issue rather than individual motor failures. By following this diagnostic approach, you can systematically identify and resolve window problems in your Chrysler LHS.
When troubleshooting why your Chrysler LHS window won't go up or down, it's essential to consider several common problems that could be at play. Start by examining the electrical system, including the fuse and relay, as these components are often the first culprits in window malfunctions. If the electrical system checks out, turn your attention to the window motor; a malfunctioning motor can prevent movement entirely. Next, inspect the window regulator, as issues here can also hinder the window's operation. Pay close attention to the window track and clips; if the window appears to shift during operation, it may indicate failing clips or debris in the track, which can be remedied with a silicone spray. Additionally, assess the master switch and wiring for any signs of damage or disconnection, as these can lead to mechanical problems rather than electrical ones. For a more in-depth diagnosis, utilizing a scan tool can provide insights into whether the Body Control Module is receiving the correct signals from the switch. By methodically checking these areas, you can effectively identify and address the issue, ensuring your window operates smoothly once again.
When windows in a Chrysler LHS fail to operate, it is crucial to address the issue promptly to avoid potential safety hazards and prevent further damage. Ignoring symptoms such as unresponsive windows or erratic behavior can lead to complications, including electrical failures or damage to the window mechanisms. For instance, if the windows are not functioning due to a disconnected battery, a simple reset may be all that is needed, but delaying this can result in more complex electrical issues. Additionally, problems like broken wires in the door jam can worsen over time, leading to costly repairs. If windows bounce back when closing, it may indicate resistance in the frame or a need for a reset, which, if left unchecked, could damage the window motor or regulator. Therefore, it is essential for DIY enthusiasts to diagnose the specific cause of window malfunctions in their Chrysler LHS and take immediate action to ensure both safety and the longevity of their vehicle.
Read about related problems experienced by other Chrysler LHS drivers like you.
See what others are asking about their Chrysler LHS. Get answers from RepairPal's community of auto experts and enthusiasts.