The engine may misfire and/or buck while driving at freeway speeds with no fault code stored in the powertrain control module (PCM). This can be caused by an intermittent fault with the camshaft synchronizer assembly. This condition can be diagnosed by monitoring knock sensor data as per Ford service bulletin #05-22-12. Replacement of the synchronizer assembly will be required to correct this concern.

Some Nissan Pathfinder owners report experiencing stalling issues after 15 minutes of driving, which can often be resolved by replacing the crankshaft sensor. However, if a knocking sound continues even after this replacement, owners may encounter additional problems such as low oil levels, ignition issues, timing problems, worn rod bearings, or faulty knock sensors. A malfunctioning knock sensor may lead to engine knocking and could trigger a trouble code like P0325. Furthermore, worn rod bearings, situated between the crankshaft and piston rods, are known to produce knocking sounds. If the check engine light remains illuminated after the crankshaft sensor replacement, it might indicate improper installation or unrelated issues with the fuel or ignition systems. While a faulty crankshaft sensor can indirectly contribute to engine knock by sending inaccurate data to the engine control module, it is not typically a direct cause of knocking sounds. Therefore, if the knocking persists, further investigation into these potential causes is advisable.