What is your question?
·
·
What is your question?
Codes P0100 and P0505 Replaced MAF sensor and Idle air Control. Car starts fine but after it warms up a bit idle lopes or bounces to stall, RPM steadily drops to stall. if you keep foot on pedal it will run fine
1 Reply
Hello, It sounds like the idle air control valve was either installed incorrectly, is the incorrect part, or is a defective part. What were your symptoms before replacement?
Symptoms were the same before the part replacement. Part is correct Toyota Part, I verified it prior to install
Ok, First, verify the installation of the IACV, then check fuel pressure. As the engine warms up, it dumps large amounts of fuel (by ratio) into the engine. When it is warm, the engine makes a more lean air to fuel ration (less fuel, more air), and this allows for fuel efficiency. If there is low fuel pressure to the engine, when the engine control module begins decreasing the amount of fuel, it may not have enough fuel to run properly.
Ok Ill check the fuel pressure, what should it be range wise? The Idle Control is in correct. I am however checking all electrical connections to make sure all is seated on connectors and parts