What is your question?
·
·
What is your question?
never any problem with this vehicle, till my lady started it this evening after it sat outside in the sxun most of the day. the pin out showing on my scan tool stated, E1 to D1 jump from the underhood diagnostic box.. Is the ABS light going to blink on the dash after installing the jumper wire ? What would be the codes for a sensor failure ?

1 Reply
it will blink out a series of flashes that will indicate a code. then you need a manual to identify the code. then you need to diag the issue. the code never identifies the failure, just the failed system. Roy
Roy, I did the jump but the ABS light stays constantly on and the cruise control light beside it goes into continuous flashing. I thought I had jumped the wrong terminals, remove the wire, the cruise control light stops flashing..Re=confirmed the terminals, try again, the same issue, the ABS is on Hard, the cruise control light does the flashing continually..I do have the various codes available,, Thanks Alan
i will try to get you a picture of this for clarification Roy