What is your question?
·
·
What is your question?
Cooling fans not turning on ... How to connect direct for them to turn on when i turn car on and they stay on ?
1 Reply
Hello, You should not attempt to hard wire the cooling fan. It is hazardous, and could result in burning the vehicle down. If the fan does not come on, test the relay, test the circuit, and test the fan motor. The procedures will be outlined plainly in the shop manual, and I highly recommend proper repair over re-engineering.
Ok sounds good i will stop at the car part store and check relays and so on thank you lots
Ok, no worries. Good luck, and let me know if you need anything.
Ok i went to autozone and connect the computer to it ... It said i need the Camshaft position sensor which is in my distributor. ... So they referred me to replace the whole distributor assembly .... Would u think thatll help? Cause it will cause engine to run poorly or not at all ... Idk to much but i will replce the fan sensors as wells
It will need testing. The codes just tell you that the engine recognized an issue based on input from that sensor, not that the sensor is bad. Auto parts stores want to sell you parts. That will not cause the fan to fail. If the cam position sensor is reporting a fault, it could be that the timing is incorrect (jumped time) or that the sensor had failed. Verify the engine is properly timed before replacing it. For the fan, it has to have power and ground, so find out where power stops and make sure the ground is good before buying parts. If you are unable to diagnose the vehicle accurately for any reason, let a pro diagnose it at least. This will keep you from throwing parts at it until it runs properly. The other part is that the engine control module could be bad, and that will cause all sorts of issues.