What is your question?
·
·
What is your question?
ON 1996 PONTIAC GRAND AM ANTI THEFT LIGHT BLINKS 7 TIMES THEN STAYS SOLID. IS THIS NORMAL DURING RELEARN PROCEDURE? SHOULD IT BLINK FOR THE 10 MINUTES?
3 Replies
Hello, what relearn process are you performing, and what diagnostic tool are you using?
Unless you replaced the tumblers inside the new lock cylinder to match the factory key so it could still be used - you do not have a compatible key now.
The ignition *KEY* is the key here. Lock cylinder itself doesn’t have to be programmed. Probably need to contact locksmith. Good luck!
kinda confused here my 96 grand am does not have chip in key so ive been told to replace ignition lock assembly and perform a relearn process. after replacing lock assembly turn ignition to start then wait ten minutes until anti theft light quits blinking turn to off position wait 5 seconds and car should start but my anti theft light does not blink stays solid?
I’m sorry that you were misinformed about the ‘correct’ procedure. Good luck with it!
As Pushrod said -- you were totally misinformed. This vehicle does require a chip key. No idea where the advice you were given came from.
thanks guys maybe i'll take that 250.00 miss information back to the parts store and contact dealer with vin# for key thanks again
To do that successfully - you’ll need to re-install the original lock cylinder. I’d contact mobile locksmith and have a *security system compatible* key made for this new lock.. IF you still have the ‘original key’ - then that won’t be a problem for a locksmith - can use original key for chip resistance reading - then cut a key for the new lock ~ using the *new key that came with the new lock* as a pattern to cut by. I hope I’m not confusing you. Either route you choose - hope you get it fixed.
it looks like I got stuck with trunk and door key was told it was ignition key guy at auto zone said no chip was necessary in key when you buy new lock cylinder as it comes with 2 keys as same kind key I have guess that was to sell product . I will work on getting a coded key and have it cut from door key thanks a million for your response . what ever happened to the good ole days and honesty
ignition lock cylinder
The key cylinder itself does not require programming of any kind. If you are programming keys, you'll need the proper diagnostic tool to follow programming procedures for the related immobilizer system.
when replacing lock cylinder doesn't computer have to relearn new cylinder
The cylinder does not get programmed. The key is programmed to the vehicle. If you haven't changed the key, then nothing needs programmed. If you have changed the key, the vehicle needs to learn the key, using a suitable diagnostic tool that usually a dealership or locksmith will have.