What is your question?
·
·
What is your question?
Crankshaft position repair advice states when the sensor is replaced its electrical connector should be checked for damage or wear. I have replaced the sensor and the connector appears to be ok but it still won't start. If the connector is bad how do I know? Can it be replaced or do i have to replace the entire harness? I would love to find a manual for my vehicle but am having trouble getting one. Any advice on repair and finding a manual would be greatly appreciated.!
1 Reply
Are you sure it's the crank sensor? If you have a good scanner you can watch for an rpm signal. If you have one the sensor and connector are good. Then check for fuel pressure. The connector is probably find. Just take a look at the pins and if they don't look burnt, widened, or corroded they should make a good contact. Alex