still getting trouble code po122 for throttle position senor

Have you or anyone tried to adjust any of the throttle settings? The throttle stop adjustment or the throttle cable? (If it has one) If so, these need to be reset. Here is the test method for the TPS: 1. Disconnect the connector from the sensor. Connect an ohmmeter. 2. Measure the resistance between terminals 1 (sensor ground) and 2 (sensor power) on 2.4L engine and between terminals 2 (sensor ground) and 3 (sensor power) on 2.7L engine. 3. Specification should be 1.6–2.4k ohm. 4. Connect an analog ohmmeter between terminals 1 (sensor ground) and 2 (sensor output), on 2.4L engine and between terminals 2 (sensor ground) and 1 (sensor output), on 2.7L engine. 5. Operate the throttle valve slowly from the idle position to the full open position, and check that the resistance changes smoothly in proportion with the throttle valve opening angle. 6. If the resistance is out of specification, or fails to change smoothly, replace the sensor.

taking batterie wont clear a code after car 1995 you will have to have a scanner clear it a parts store will do it for free in most states

idle air control valve