What is your question?
·
·
What is your question?
I had put a new door on my car, it is the front side passenger door. The door is a little lower at the back causing it to hit the rear door slightly. How do I raise the door to fit properly? I have already losen bolts and tried to raise it but that did not work.
1 Reply
The door hangs on the hinges at the front, all hinge bolts have to be loosened to adjust, because of the door weight this can be hard to adjust if have no experience. There are also depth adjustments to be made. Be careful. If can close and set where you want the door when latched then do so and reopen very carefully and open slightly while holding weight of door, set on a raised floor jack with a piece of 2x4 on the pad for paint protection and then roll back easily on a level surface to hold same door adjustment to allow for retensioning of bolts. You do not have to tension all bolts each time to double check, just make sure you retension all after the correct adjustment is achieved.