Coil Test

It may be beneficial to understand why you want to test the coil pack, but here you go. You are going to need a Digital Volt Ohm meter, set it to the Ohms position, and put one lead into the secondary terminal for cylinder 1, and the other lead for cylinder 5. next move the leads to cylinders 2 and 6, then to cylinders 3 and 4. The readings you will have obtained are your secondary winding resistances, make sure they are all within about 1,000 ohms of each other. To test the primary windings you will have to disconnect the electrical connector at the coil pack, then take one of you leads and place it on pin #4, this terminal is where battery voltage comes into the coil pack. Next, take your other test lead and touch it to pin #3, the pin #2, then pin #1, again, all of these readings should be within about .5 ohms of each other. Maybe if you were a bit more detailed about what your problem is I could help you out more specifically.