What is your question?
·
·
What is your question?
How would I be able to figure out what is causing it to Misfire while doing 50mph? She also has a high beam out that I cannot get to work I've changed bulbs, fuses and ohms metered from fuse to connector. Is there anything in over looking?
2 Replies
is the check engine light flashing?if it is that means it is a severe misfire which could be damaging,overheating and melting your catalytic converters,which could be very expensive.you need to have it diagnosed properly with a good scan tool,to identify misfiring cylinders,then test for cause of misfire,and may need to check compression.these ford escapes are known for the ignition coils shorting out.
Is the check engine light on? Two possibilities I can think of right now......possible start of a fail on an o2 sensor or possible restriction in the exhaust system.
The check engine light is on and it just stays on. Her high beam doesn't work and I've changed bulbs fuses and ohms metered to the switch and I can't find anything wrong
Get the check engine light read for free at an Autozone and post results to further assist you. Wait Autozone won't do that in CA.....need read from a garage or anyone you know with an OBDII reader or buy one....About the high beam, possible loose ground? I would have to see to know for sure....
Thank you very much
The check engine light is on and it just stays on. Her high beam doesn't work and I've changed bulbs fuses and ohms metered to the switch and I can't find anything wrong