What is your question?
·
·
What is your question?
Pulling trailer and with no warning, I pressed the clutch to shift gears, would not go into any gear. Had to stop, turn off engine, put truck in a gear, and then start off again. Had to start off in 2nd, get to the top of a hill- turn it off and put in 3rd and crank up again. The clutch would disengage the transmission going down hills if pressed so I could coast. A friend swapped out a fuse relay and it started working again, but is this the real problem and solution ? - or did we just get lucky it started to work again by accident?
1 Reply
I don't know how a fuse helped the hydraulic clutch system, but normally the fluid is low or the clutch master cylinder and/or slave would be the issue.