What is your question?
·
·
What is your question?
Now will start run great then after a few miles will stall, turn over, will not feed fuel, then after a little time will start run great, but when it stalls out, no check engine light will come on,but will turn over, when it starts no codes will show check engine light come on when you on the ignition like normal. Changed the fuel pump, fuel pump relay, shut off relay. No pressure on rail when it shuts off. Is the my ECM module???
What makes this problem better or worse?
runs cold great
2 Replies
copy and paste the link below https://repairpal.com/numerous-conditions-may-cause-engine-to-crank-but-not-start-933
On the passenger side - check the PCM wiring for any signs of damaged insulation - also wiggle testing that big wiring harness may reveal any wiring problems .. When engine stalls - turn key on - start wiggling the harness and listen for clicking / buzzing sounds that indicate system is powering back on .. This is just something I've run into on a few occasions and intermittent failures are quite common. You really need a wiring schematic so you can test the PCM ground circuit to the ASD relay. I can't remenber the connector pin number or wire color .. It's been awhile. Good luck!
The Auto Shut Down (ASD) relay *must* be energized before the engine will start!! ASD relay ground circuit IS supplied via PCM. I’m thinking black wire with white tracer.
I do have wiring diagram I will check the ground feed and the power to the ECM. If they are in good condition do would you replace the ECM?
Not until all other possibilities have been investigated. Make SURE the ASD relay is turning on .. You’ll need to check for ground ‘from’ the PCM ‘to’ the ASD. IF the ground circuit has failed ‘inside’ the PCM - there IS a way around that - I’ve done it! Now you can’t just simply ground that circuit to metal - but it is doable. Let me know.
I will do that, thanks. If it does not work then may I get in touch with you then??
âœ”ï¸ - - Read back over this page.