What is your question?
·
·
What is your question?
I have a 2003 Chevy Silverado , i was replacing the ignition switch with a AC Delco, the key was able to start before all this but after replacing the ignition switch the key was just moving freely and not turning on anything, the ignition switch was locked into place, the reason for replacement was because gauges would go out, headlights and locks would go out at the same time but after turning off and on vehicle then it’s good again but the truck did not want to start this time after installing a new one in, so I put the original one back in and it turns on all the accessories but when I put it on run and try to crank it, it won’t go pass the crank position, I can go to the off, acc and on position but will not go pass to engage the starter, I took out the ignition switch and I was able to start the trunk but manual moving the gear but the key will not go pass it, is it because of the relearn procedure that needs to be done or what could this issue be?
How long has your 2003 Chevrolet Silverado 1500 had this problem?
One day
2 Replies
It sounds like there is something not being installed properly, or additional concerns in the steering column related to the key cylinder and ignition switch. It's really difficult to make suggestions without being about to see and touch your ignition from where any of us sit. Local professional guidance is the best suggestion we can give, because it would take some working with it and inspecting to find out what is wrong.
You simply have the replacement electrical switch out of time with the lock cylinder.
It’s too difficult to explain / relay the correct procedure online so I found a video that should help: https://youtu.be/o5bayy-BLS8 It’s a common mistake - the KEY here is observing the exact position of the ‘white gear’ on the old switch when it is removed - then set ‘white gear’ on new switch to same position - install without rotating key until new switch is FULLY SEATED. It’s a pretty easy fix though - you’ll just have to experiment with it a bit - however as suggested you can always seek *hands-on* assistance from a pro. Good luck!