Burned out lamps

Not sure about the fog lamps. But just did the bulbs in the light bar that is on the trunk lid. Not difficult. First remove the trunk liner on the trunk lid. Pry out the plastic push pins (about 12), unscrew the two cargo net loops, one on each side of the lid. Work the lining down over the center latch and the safety trunk pull latch and remove lining. Now remove the nut and washers from the studs that hold the light bar in place (8 or so). I think they were 10mm. A deep well socket is best. Now the light bar can be lifted straight up and main power line to bar can be disconnected at locking connector. Each of the studs has a rubber seal on the outside that will be stuck to the metal lid. Mine were hard to get pull loose, but when they are all loose the bar will come right off. Then replace the bad bulbs as usual. Probably should put some silicone sealer on stud washer to keep out rain when installing light bar. Plan for a couple of hours if everything goes well. Remember Murphy may show up. flowood