What is your question?
·
·
What is your question?
turn over slow all dash light,s is working put new coil pack on it new crank senor new camshaft senor on it new oxygen sensor on it new auto shutdown relay new, code,s are p o 340 is a new one on it and it will not come off after reset pm o601 butn it,s been on it for a year run fine till thin no leak.s or noise
What makes this problem better or worse?
no
How long has your 2001 Chrysler PT Cruiser had this problem?
a few week,s
2 Replies
Hello, P0340 as a hard fault would indicate some kind of electrical short in the circuit. This code typically comes on when the vehicle stalls due to loss of sensor signal -- not as a result of any fault. However, if the code does not clear, there is a "hard fault" from an active problem with the circuit. Troubleshooting is needed. Even so, you still do not know what is going on - no spark? No fuel? No air? Timing off? No compression? Hands on testing is needed, and not just "codes".
What is the significance of the two deer jumping out in front of you? Did the vehicle strike the deer then all this happened?
In other words - did you hit a deer and now you’re having problems with the vehicle??