Manual trans
1990 Ford F-150

Manual trans

(1990 Ford F-150)
recently i had a broken mount for clutch and brake pedal assembly replaced it and also master cylinder shaft had wear so i replaced it bleed lines now the vehicle starts but wont shift into gear have a new clutch and a slave cylinder dont now what to do next
1 answer & 0 comments
Popular Answer
on September 25, 2010
I'm thinking you have the Mazda 5 speed manual transmission (M5OD)? This is the one with the slave cylinder inside the bell housing of the transmission. These are very challenging to bleed air out of fully, so I would say first to try and re-bleed the clutch system. Can you build pressure by pumping the clutch pedal? Does it have a good feel? Has the clutch itself been replaced?

Start with the re-bleed and go from there.
Sign in to reply
General Diagnosis
$88 - $111 Learn More
on September 25, 2010
I'm thinking you have the Mazda 5 speed manual transmission (M5OD)? This is the one with the slave cylinder inside the bell housing of the transmission. These are very challenging to bleed air out of fully, so I would say first to try and re-bleed the clutch system. Can you build pressure by pumping the clutch pedal? Does it have a good feel? Has the clutch itself been replaced?

Start with the re-bleed and go from there.
Sign in to reply

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
Do the starter bolts go into the bell housing 3.7 i5 engine, 4l60e auto trans, a-series
2002 nissan xterra 3.3 6cyl, man trans. i'm doing an engine swap. will the same engine but had an automatic trans...