The total repair cost will vary based on the condition of your vehicle and the number of repairs needed to fix your symptom. Proper diagnosis will save you money by finding the exact repairs needed to fix your car right the first time.
If the door window motor fails, the window may not open or close, or it may operate intermittently. Traditionally, problems with power windows were caused by faulty switches or electrical wiring - especially the wires running between the door and the vehicle body that are subjected to repeated flexing. In these cases, the window might operate intermittently when the door is opened and closed. While this may still be the case on newer cars, it is increasingly common to find window motor problems that originate with a control module. Still, the switches and wiring should be checked thoroughly before replacing a window motor.
If one of the windows in a vehicle will not open or close properly, a failing door window regulator might be the cause. A window that is moving intermittently, or one that gets stuck on the way up or down, could also indicate a broken regulator. Other symptoms might include a clicking, chattering, or grinding noise when the window moves. In some cases a severely damaged window regulator could cause the window to drop inside the door.
When a switch can not make contact and close the circuit, the window cannot be raised and lowered. If the switch on the driver's door will not raise or lower the window in question, but the switch on the corresponding door works just fine, this is a good indication that there is a switch failure. This works the other way around, as well. If the switch on the door does not cause the window to function, but the driver's switch does, that is an indication of a passenger door window switch failure.
Due to the nature of electrical systems on modern vehicles, the range of problems these can cause are nearly limitless. However, there is a way to categorize them in two ways. Permanent and intermittent problems. Permanent problems appear and remain. This may be the vehicle will not start, the radio does not work, or the door chime will not turn off among many, many others. These problems are more straight-forward to diagnose since they present themselves at all time. This means there will always be a fault to find. Intermittent electrical problems, however, can be difficult or impossible to locate, since they appear then disappear without warning. The best case scenario for an intermittent issue is when replicating the problem is easily accomplished and understood. This allows a technician to make an issue semi-permanent, allowing them to find the fault. Other issues that come and go without warning and cannot be replicated on demand must occur when the technician is servicing the vehicle, otherwise there is no problem to correct. It is most important to understand that electrical system faults always require inspection, and can include the vehicle working in any manner, or not working at all.
Like we noted in the last section, general diagnosis symptoms are the most vague of the bunch. There are several diagnostic spectrums, electrical diagnosis, drivability diagnostics, engine diagnostics, transmission diagnostics, and the list could continue for about 5 or 10 more spectrums of diagnostics. The most important take-away here, is that general diagnostics are diagnostics that have no other spectrum in which they fit, or the problem is unknown. This means that any vehicle left outside of a repair facility with the keys and an authorization to perform diagnosis will be diagnosed under the general diagnosis spectrum.
When troubleshooting power window issues in your Jeep Cherokee, start with the most straightforward solutions to save time and effort. Begin by checking the power window fuse, as a blown fuse can prevent all windows from functioning. Locate the fuse panel in the engine bay and inspect the number 12 fuse for any signs of damage. If the fuse is intact, consider whether the battery has been recently replaced or disconnected, as this can affect window operation, requiring you to hold the switch to fully open or close the windows. If the windows still do not respond, the next step is to examine the window regulator, which may have failed if a window is completely unresponsive. Lastly, if the switch illumination works but the window does not operate, the issue may lie with a faulty power window switch, particularly in the rear door. By following this diagnostic approach, you can systematically identify and resolve the power window issues in your Jeep Cherokee, making the repair process more manageable.
When your Jeep Cherokee window won't go up or down, it's crucial to methodically troubleshoot the issue by examining several common problems. Start by checking the electrical system, as a blown fuse or faulty relay can disrupt the window's operation. Next, inspect the window motor; if it's broken, the window may not respond at all or could operate erratically. The window regulator is another critical component to check, as it directly controls the window's movement and can fail over time. Additionally, look for any wiring issues that might be causing a short or disconnection, which can prevent the window from functioning properly. Don't overlook the window switch itself, as a malfunction here can also lead to a lack of response when you attempt to operate the window. Lastly, if you've recently replaced or disconnected the battery, this could affect the auto window functionality, requiring you to manually hold the switch to operate the window fully. By addressing these areas, you can effectively troubleshoot and resolve the issue with your Jeep Cherokee window.
When a window in your Jeep Cherokee stops functioning, it’s crucial to address the issue promptly to avoid potential safety hazards and additional repair costs. A malfunctioning window can compromise your vehicle's security, allowing unauthorized access, and can also affect your comfort and visibility while driving. Common causes such as a blown fuse, a faulty window motor, or damaged wiring can escalate if left unchecked, leading to more extensive electrical problems. For instance, if the window regulator fails, it may require a complete replacement, which can be more costly than a simple fuse change. Additionally, if the issue stems from a damaged wire harness, particularly near the door hinges, it can lead to further complications in the vehicle's electrical system. Therefore, diagnosing the specific cause of the window malfunction is essential not only for restoring functionality but also for ensuring your safety on the road. Taking immediate action can save you time and money in the long run, making it a priority for any Jeep Cherokee owner experiencing window issues.
See what others are asking about their Jeep Cherokee. Get answers from RepairPal's community of auto experts and enthusiasts.
Read about related problems experienced by other Jeep Cherokee drivers like you.
