Close
QUESTIONS

RepairPal is your advocate for car care advice and guidance

Q: How do I change the outer taillight bulbs? on 1992 Lexus LS400

Rookie cbe0621eac06868b3efe0d8d1d3611e23c60d3114864ea2ec19a68cfbd3eebab
How do I change the rear taillight bulbs on my Lexus LS 400. The left and right rear . How do I access
No car image 94a1663db56199c5353592009e34aaa51078a2469bed068bb8d6f0ba43accf97
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more
Found online:

Rear Combination Light
REPLACEMENT OF REAR COMBINATION LIGHT


REMOVE REAR COMBINATION LIGHT
(a) Disconnect negative (-) terminal from the battery.

CAUTION: Work must be started after approx. 90 seconds or longer from the time the ignition switch is turned to the "LOCK" position and negative (-) terminal cable is disconnected from the battery.



(b) Remove the side cover and trim rear cover.
(c) Remove two bolts.
(d) Disconnect connector and remove the grommet.
(e) Remove rear combination light.
(f) Remove bulbs and sockets.
(g) Remove the wire harness.

INSTALL REAR COMBINATION LIGHT For installation, follow the removal procedure in reverse.






Rear Combination Light
REPLACEMENT OF REAR COMBINATION LIGHT


REMOVE REAR COMBINATION LIGHT
(a) Disconnect negative (-) terminal from the battery.

CAUTION: Work must be started after approx. 20 seconds or longer from the time the ignition switch is turned to the "LOCK" position and negative (-) terminal cable is disconnected from the battery.



(b) Remove the side cover and trim rear cover.
(c) Remove two bolts.
(d) Disconnect connector and remove the grommet.
(e) Remove rear combination light.
(f) Remove bulbs and sockets.
(g) Remove the wire harness.

INSTALL REAR COMBINATION LIGHT For installation, follow the removal procedure in reverse.
Rear Light Assembly
REPLACEMENT OF REAR LIGHT ASSEMBLY


REMOVE REAR LIGHT ASSEMBLY
(a) Disconnect negative (-) terminal from the battery.

CAUTION: Work must be started after approx. 20 seconds or longer from the time the ignition switch is turned to the "LOCK" position and negative (-) terminal cable is disconnected from the battery.



(b) Remove the luggage compartment door trim.
(c) Disconnect connector.
(d) Remove five nuts and rear light assembly.

INSTALL REAR LIGHT ASSEMBLY Follow the removal procedure in reverse to carry out installation.



Didn't find what you were looking for?