What is your question?
·
·
What is your question?
I swapped all seats from one explorer to the other and the airbag light is been on since the change. Does this mean I need to swap the seats sensors as well. How can I fix this issue. Thanks so much...Rafael. Bloomfield, Ct
1 Reply
The problem with the Ford's electrical system is that they use "slop fit" terminals. Roll the seat forward and pull the terminal blocks back for access. With an ohmmeter, test both sides of each wire for continuity thru the connector. Write down the color of the wire that reads infinity, or no continuity. Unplug the connector and check if all the pins on the male side are there and in good shape.On the female side, using a very small screwdriver, or nail, close the terminal slightly to have a tighter fit on the pin. Reconnect and test. Do this for each seat with a sensor.
Ok, thanks for taking time to help! I will try that! Again...Thanks a whole lot!