Throttle Position Sensor Replacement

What is a throttle position sensor?

Throttle position sensors are mounted to the side of the throttle plate and measure the position of the throttle — essentially, how far down the gas pedal is pressed.

How does the throttle position sensor work?

By reading the position of the throttle, the sensor indicates how much air is being let into the engine. The car's computer uses this reading to send the correct amount of fuel to the engine, where it mixes with the air and is burned.

When a throttle position sensor is defective, the vehicle may hesitate, misfire, or jerk on acceleration, shift poorly, and display uneven power characteristics.

The Check Engine Light may illuminate with a fault code set for one or more throttle position sensors.

What are the symptoms related to a bad throttle position sensor?

When the throttle position sensor fails, the engine's computer tends to overcompensate with fuel, leading black exhaust coming from the tailpipe. There is a strong possibility of engine misfires, and the check engine light will come on. Throttle position sensors can also develop "dead spots," or certain places along the throttle curve where it doesn't get a reading. When this happens, the above symptoms can occur but then stop when you further press or let off the gas pedal.

Can I drive with a throttle position sensor problem?

When the throttle body position sensor fails, the vehicle may not start, or may start and then stall. Even if the car keeps running but idles roughly, it's best to get it repaired right away to avoid damaging other, more expensive parts.

How often do throttle position sensors need to be replaced?

Throttle position sensors failure is fairly common. The average lifespan of a throttle position sensor is just over 80,000 miles. There is no maintenance for a throttle position sensor — it simply needs to be replaced after it stops working correctly.

How are throttle position sensor issues diagnosed?

The technician will use a scanning tool to check for codes pointing to problems with the throttle position sensor. This also allows the technician to see operating conditions in real time. The technician will also check whether the sensor is adjusted properly in relation to the throttle plate.

A throttle position sensor code isn't always triggered by a defective sensor. It can be triggered by a defective crankshaft position sensor, MAP sensor, mass air flow sensor, ignition problem or defective PCM.

How is a throttle position sensor replaced?

The battery must be disconnected, and other parts, such as an engine cover or strut brace, may need to be removed. The throttle position sensor is located opposite the spring for the throttle cable, and can be removed with a connector and a couple of screws. The sensor can be pulled out and tested, and the new sensor installed in its place.

Throttle Position Sensor Replacement

Jump to:Cost estimates by year Commonly associated repairs Related OBD codes Cost estimates by vehicle

What is a throttle position sensor?

Throttle position sensors are mounted to the side of the throttle plate and measure the position of the throttle — essentially, how far down the gas pedal is pressed.

How does the throttle position sensor work?

When a throttle position sensor is defective, the vehicle may hesitate, misfire, or jerk on acceleration, shift poorly, and display uneven power characteristics.

The Check Engine Light may illuminate with a fault code set for one or more throttle position sensors.

Throttle Position Sensor Replacement

What is a throttle position sensor?

How does the throttle position sensor work?

What are the symptoms related to a bad throttle position sensor?

Can I drive with a throttle position sensor problem?

How often do throttle position sensors need to be replaced?

How are throttle position sensor issues diagnosed?

How is a throttle position sensor replaced?

Need a repair? Trust our RepairPal Certified network.

Quality Car Repair.
Fair Prices.