alarm set

The only way to disable the alarm system is with the Remote (RKE) or by use of the keys in the Drivers or Passenger Door, or lifgate locks.Try all three locks to disarm the system. The switches on these locks are known to fail over time, thus preventing you, the operator from arming or disarming the system with a key, however it is not likely that all three switched have failed. If the Alarm system does not respond to the key or the Remote (RKE), take your vehicle to local dealership. Your dealership has the proper diagnostic test equipment to check all of the VTSS functions. There is also the posibility of a defective Body Control Module (BCM) SUMMARY: Vehicles equipped with the Vehicle Theft Security System (VTSS) system, the doors, liftgate, hood and ignition circuit are monitored by the Body Control Module (BCM) when the system is armed. The VTSS will prevent the engine from starting until the BCM receives a disarm signal. If the VTSS is triggered, the horn will pulse, headlamps/marker lamps will flash, and the VTSS warning lamp will flash. If BCM determines the threat to be false and the VTSS is not triggered again, the system will shut down and rearm itself after three minutes. The VTSS monitoring portion of the system is split into two sections. The engine compartment section and the passenger compartment section. If a malfunction occurs in the engine compartment section, the passenger compartment section would still arm and function normally. NOTE: If hood is not secure during arming sequence, the lamp will stay lit and not flash. The system will arm with hood not secured (hood ajar switch closed) System will not arm if passenger compartment is not secure (all switches open).

I have a 1996 chrysler town & country, change the battery and it start sounding alarm and wwon.t start cos of the alarm. What shoud I do.