Definitely need to do proper tests first before jumping to conclusions. Check for power at the fuel pump using a voltmeter as a friend cranks over the engine, if no power you need to check out the electrical circuit relay ect... you need a wiring diagram and test procedures. Using a mechanic's stethoscope (or use a long screw driver placing the handle end up to your ear place the metal tip end of the screwdriver against the body of the fuel injector), get a friend to crank over the engine while you "listen" to the fuel injector listen to each injector at the same point of the injector body. You should hear "click, click, click" as the injector is electrically opened and closed by the computer. If the injector is not being triggered you will not have fuel getting into the engine's cylinders. Disconnect the electrical connector at the fuel injector with the ignition key in the "on" position, (next position after the accessory position) you should have 12 volts at one of the two wires at the injector. There is a company that independent auto repair shops get their information from, this same information is available inexpensively for people that work on their own cars.. The information is year make and model specific, covering repair procedures, torque specifications, fluid capacities and specifications, service bulletins, component locations, wiring diagrams ect.... Alldata is very easy to navigate http://bit.ly/AllData_Repair_Manuals_Online