car stahls while driving and will not restart until codes have been cleared.

What is your question?

I have a 2005 mote carlo 3.8 with 195000 miles. it will runs fine but will stall out after driving just a few miles {2-15}. it will just shut down and will not restart. it sets a mass air flow code and will start and repeat this as soon as you clear the code. the mass air flow sensor was replaced with a known good part but the problem persists. It will idle fine for as long as you want . the problem started within 100 miles of the engine being washed off but ran fine immediately after that had been done. an abs connector on the right front had just been installed and the codes for that cleared. any suggestions?