RepairPal is your advocate for car care advice and guidance

Q: P0441 on 2003 Dodge Ram 1500

Enthusiast 01be16a5a93688912f14755221fb15211b518d9a788cf01b455e03cc1bd585ac
What is causing this code on my 5.7 Hemi engine, I have had the code erased once and it has come back after about 400 miles being put onto the truck?
No car image 94a1663db56199c5353592009e34aaa51078a2469bed068bb8d6f0ba43accf97
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more
Vehicle Application: 2003 Dodge Ram 1500 Pickup 4.7L, Vin N, Eng Cfg V8 2003 Dodge Ram 1500 Pickup 5.7L, Vin D, Eng Cfg V8

Customer Concern: The check engine light is on. The engine runs good.
Tests/Procedures: 1. Verify that the hoses for the purge solenoid are routed correctly and not pinched or restricted in any way. This includes verifying the lines to make sure there is no liquid fuel or charcoal in the lines. Clean as needed or replace the lines as needed.

2. Verify that the canister purge solenoid will vary duty cycle when commanded to by the scan tool. Replace the solenoid if sticking.

3. At the Natural Vacuum Leak Detection (NVLD) assembly, which is located at the front of the charcoal canister, near the front of the fuel tank, backprobe the Orange wire with a voltmeter. Locate the vacuum line going to the canister and remove the line so a hand vacuum pump can be used to put vacuum on the line going towards the NVLD. The other line at the NVLD goes to the vent. Block the vent line. Using a hand vacuum pump, apply vacuum to the line while watching the voltage on the Orange wire. Voltage is supposed to change at approximately 1 inch Hg vacuum. Try testing this switch several times to see if the switch is sticking. Replace the NVLD if the switch is sticking.
Potential Causes: Hoses
Natural Vacuum Leak Detection (NVLD) Assembly
Purge Solenoid

Diagnostic Codes: P0441
Didn't find what you were looking for?