What is your question?
·
·
What is your question?
When you press the 2WD button, it will only blink and then stop blinking. The 4WD light stays lit all the time and won't shift out of 4WD period. I have replaced the 4WD actuator to no avail. What else could be the problme? (At first, it would do this intermitantly and always go into 2WD after a couple of minutes, not it won't.)
1 Reply
You have to make sure that the the switch is telling the actuator to change modes. Then if the actuator is getting the correct signal and you have installed a new factory actuator, then the transfer case needs to be torn down,inspected and repaired.
I have checked the switch, (inside the cab), and it is working correctly. Someone told me that the transfer case motor may also be the problem, but I am unable to get to it, so I am not sure. Thanks for the help.