2008 Mitsubishi Eclipse Head Gasket Replacement Cost

Failed head gaskets or damaged cylinder heads can cause engine coolant to leak into the combustion chamber, producing a white, sweet-smelling smoke from the tail pipe.

When the head gasket begins to fail, the engine may have no symptoms at all. They only begin to occur when the leak has reached an engine oil passage, engine coolant passage or the engine cylinder. When that happens, the engine may be very difficult to start, and run roughly when idling. There may be oil or coolant leaking, and the engine may begin to overheat, or at least run hot. At this point, there may be coolant in the engine oil pan — this will look creamy and lighter in color than the oil. Also, the radiator or engine coolant reservoir may have a gurgling sound, the presence engine oil, or smell of combustion. And the check engine light will come on. The coolant being burned in the engine will produce white exhaust that smells sweet, like engine coolant. When the head gasket fails completely, the engine will overheat within minutes of starting, will stall and then won't restart.

Driving with a bad head gasket is hazardous to the engine, and may even be impossible. A failing head gasket typically will lead to your engine overheating and will eventually ruin the engine block, cylinder head, or both. A car with a blown or leaking head gasket should both be towed to a repair facility.

Head gaskets can fail at any time, but they typically last at least 100,000 miles, especially if the oil and coolant are properly maintained. In order to keep the gasket in good condition, dirty or contaminated fluids should be replaced on schedule, and the engine must run at the proper temperature. This is the best way to help prevent head gasket failure, along with avoiding aggressive driving.

In general, there are a few signs that will point to head gasket failure. If engine oil and coolant are found mixed together, either in the engine or in the cooling system, the gasket is often the culprit. Further testing will be done, and a machine shop will try to confirm whether the head gasket is the problem.