Learn About Your Car

Are you interested in certification?

Blower Motor Resistor Replacement

What is a blower motor resistor?

The blower motor is a fan housed in the heating, ventilation and air conditioning (HVAC) ducts, normally located behind the glove box. It uses a resistor to change the speed at which the fan operates.

How does the heater blower motor resistor work?

The air conditioning and heating controls allow you to switch fan speeds — and the blower motor resistor controls that speed once you select it. The resistor is between the power source and the fan, and allows only the desired amount of power to go to the fan. When the fan receives less power, it turns slowly, and when it receives more power, it will speed up.

Often when the heater blower motor resistor fails, the blower fan will operate only on the highest speed and none of the lowest speeds.

What are the symptoms related to a bad heater blower motor resistor?

When the blower motor resistor fails, the air conditioner and heater may still work, but air may blow from the vents at only some of the fan speed settings. If the resistor isn't replaced for some time after starting to act up, it may fail completely, leaving the entire system useless.

Mercury Blower Motor Resistor Replacement Cost Estimates

The average cost for a Blower Motor Resistor Replacement is between $89 and $117 but can vary from car to car.

Mercury Grand Marquis

Mercury Tracer Blower Motor Resistor Replacement Cost by Year

The average cost for a Mercury Tracer Blower Motor Resistor Replacement is between $89 and $117 but can vary from car to car.

Show All Years

More RepairPal Resources

Blower Motor Resistor Replacement

Jump to:Cost estimates by vehicle Cost estimates by year

What is a blower motor resistor?

How does the heater blower motor resistor work?

Often when the heater blower motor resistor fails, the blower fan will operate only on the highest speed and none of the lowest speeds.

What are the symptoms related to a bad heater blower motor resistor?

1996 Mercury Tracer Blower Motor Resistor Replacement Cost

The average cost for a 1996 Mercury Tracer Blower Motor Resistor Replacement is between $89 and $117.

Labor costs are estimated between $61 and $90 while parts are typically priced around $28.
This range does not include taxes and fees, and does not factor in your unique location. Related repairs may also be needed.
For a more accurate estimate based on your location, use our Fair Price Estimator below.

Can I drive with a heater blower motor resistor problem?

Driving with a defective blower motor resistor can be inconvenient, but there's no safety risk. If it has failed completely, you won't be able to use the heat, A/C or even the fan, so that won't be fun during extreme heat or cold.

How often do heater blower motor resistors need to be replaced?

Blower motor resistors aren't a maintenance item — they don't have a set replacement schedule. They can last the life of a vehicle, and age can be a factor as the plastic can become brittle over time, or heat may cause electronic failure. The amount of use a blower motor receives may also be a factor.

How are blower motor resistor issues diagnosed?

The mechanic will perform a series of tests that can lead to the blower motor resistor. This includes checking fuses and making sure the resistor is receiving power. If power reaches the blower motor resistor, but the blower motor does not receive that power, the resistor is probably faulty. It will be removed, inspected and bench tested to make sure it's the culprit.

How is a blower motor resistor replaced?

Either the glove box or lower cover will be removed from the dashboard to grant access to the blower motor service cover. The cover is removed, and the blower motor resistor is disconnected from its electronic connectors. Finally, the blower motor retaining screws will be removed, and the blower motor will be taken out. The new resistor will be installed into the blower motor, and then the unit will be put back in the reverse of the order listed above.

RepairPal recommendations for blower motor resistor issues

Testing is imperative to making a proper diagnosis. We recommend disconnecting the battery any time there is an open electrical circuit.

Can I replace the heater blower motor resistor myself?

A skilled DIYer can accomplish this diagnosis and repair. A basic understanding of a series electrical circuit, a few basic tools, and a digital voltage meter are all that is required. It's important that the DIYer understand the testing procedures for the blower motor circuit, as failing to properly test the blower motor may lead to unnecessary costs. If you feel uncertain about this repair, take it to a certified mechanic instead.

Get a RepairPal Fair Price Estimate® for your 1996 Mercury Tracer.

Our Fair Price Estimate will help you avoid overpaying based on your car, needed service, and labor rates in your area.