1991 Buick Reatta Oil Pan Gasket Replacement Cost

The engine's oil pan is attached to the bottom of the engine. It holds the engine's oil capacity, acting as a reservoir for oil circulating through the engine's oil passages. The oil pan gasket is sandwiched between the bottom of the engine block and the oil pan to keep circulating oil inside the engine.

An oil leak may be noted on the ground where the vehicle is parked. However, many vehicles have plastic trays underneath the engine that may catch leaking oil and conceal the leak. In such cases, a low oil level, a burning oil smell, or even smoke from oil burning in the engine bay may be noted. »MORE: Signs of a bad oil pan gasket

A vehicle can still be driven with a leaking oil pan. However, it will become necessary to check the oil and top the oil level off more often. A leaking oil pan increases the risk of driving with insufficient oil in the engine, starving oil driven parts. Damage to timing chain tensioners, camshaft bearings, crankshaft bearings, and other oil lubricated components is probable if the vehicle is driven with low oil.

Repair intervals vary greatly by vehicle and driving conditions. The oil pan gasket does not wear like a tire or a ball joint, but eventually the gasket's rubber or cork will degrade to the point of leakage. Often, leakage of the oil pan gasket is visible during normal servicing (such as an oil change) so it typically doesn't go unseen for too long.

It is easiest to spot oil leaks when they are new or fresh. The technician may clean the fluid around the leak and direct you to come back later to confirm where the leak is coming from. With more progressed oil leaks, the technician will also add a dye to the oil. After the vehicle has been driven with the dye, a UV light will be used to pinpoint the leakage and recommend repair.

The technician will drain the oil and remove the oil pan from the engine. Removal of the oil pan may require raising of the vehicle or removal of the front subframe. The mating surfaces on both the engine block and the oil pan will be cleaned and a new gasket will be applied. Some vehicles have a paper gasket, while others may only require an application of sealant according to the manufacturer. Once the pan is installed, the engine oil will be refilled to the correct level and the technician will check for leaks to ensure a proper repair.

Proper diagnosis is needed to pinpoint the leak. An external head gasket leak, a split line, or a crank seal can also be the source. The oil pan itself should be inspected. Many vehicles have cast oil aluminum pans that can crack and continue to leak after the pan gasket has been replaced. Motor mounts should be inspected. Oil leakage can weaken them and it may be convenient to replace them during this repair.

Oil is damaging to rubber components like hoses, belts, and motor mounts. Continued oil leaks onto the these components will cause premature failure. With an oil pan leak, it also becomes even more important to check the oil level. The oil in the lubrication system is under pressure, so driving with an oil leak is forcing oil out of the seam between the oil pan and the engine block. An oil leak increases the risk of driving with insufficient oil in the engine, starving oil driven parts. Damage to timing chain tensioners, camshaft bearings, crankshaft bearings, and pistons is probable if the vehicle is driven with low oil.

Repairing your own car is an extremely rewarding process that can also save you money. But before you dive in, it’s important to be sure the issue has been properly diagnosed. Seemingly obvious symptoms can lead the inexperienced down a rabbit hole of replacing parts that don’t fix the problem. Proper diagnosis can save more money than guessing at what’s broken! If you're unsure you have the right tools or experience to diagnose a problem, consider reaching out to a RepairPal Certified Shop. Before ordering parts or attempting this repair yourself, look online for guides on how to replace the oil pan seal on your specific vehicle and engine variant. Some vehicles require lifting of the motor, removal of the front subframe, or special tools for disassembly in order to remove the oil pan. Some sealants also require time to set, leaving the vehicle immobilized until the job is completed.